Hard Top Keypad
H2: Film Injection Assemble with Silicone Keypad

Product Characteristic
Section Drawing
Design Information

PRODUCT CHARACTERISTIC

This kind of product was produced by using automatic mambrane printing facility and silicone rubber molding techonoly.
 
Llight, thin, short and small.
No abrasion endurance issue.
With good back-lighting effect.
Can be design with multiple colors.
With soft-tactile feeling.


SECTION DRAWING



DESIGN INFORMATION

Rubber Keypad:
1. Draft angle 1°.
2. Key top edge radius 0.3mm.

IMD:
1. Draft angle 1°.
2. Key top edge radius R 0.5mm.
3. Gap of key to key Free height.
4. Thinkness of film: 0.1mm, 0.125mm, 0.175mm

 

   
Copyright © 2006 Silitech Technology Co. All rights reserved.